Cooling # how to recover HVAC refrigerant? Licensed professional required Refrigerant work is restricted by federal law — only EPA Section 608 certified technicians may purchase or handle refrigerant for stationary equipment. Refrigerant circulates in a sealed loop and is not consumed, so a system that is low on charge has a leak. Only a technician certified under EPA Section 608 may purchase or handle refrigerant for stationary equipment, which means topping it up yourself is neither a legal nor a technical option. ## Why does this matter? R-22, R-410A, R-454B and R-32 — the regulation, and what it means for your equipment. This question falls on the professional side of the line. That is not excess caution: refrigerant work is restricted by federal law, combustion faults produce carbon monoxide, and a capacitor holds a dangerous charge even with the power switched off. ## How often does this answer change? This page is marked volatile, meaning its content depends on rules that change. We re-verify it every 90 days against the primary source and stamp the date above. If that date looks old, treat the figure as suspect and check it against the authority we cite. ## What is happening with refrigerants? This is the part of the industry that moved most between 2023 and 2026, and the part with the most outdated content. Three things shifted at once: R-22 production ended, a GWP limit took effect for newly manufactured equipment, and EPA revised the installation deadline in May 2026. ## Which efficiency numbers can you actually compare? If you are comparing efficiency figures, check which generation they belong to first. On January 1, 2023 DOE changed the test procedure and renamed three metrics: SEER became **SEER2**, EER became **EER2**, and HSPF became **HSPF2**. The current procedure measures at a higher external static pressure, much closer to what equipment meets once installed in a real house on real ductwork. DOE is explicit about the consequence: "Although SEER2, HSPF2, and EER2 ratings are similar to ratings using the original metrics, they are not directly comparable. Compliance with the new standards for each model must be determined based on its measured SEER2, HSPF2, or EER2." In practice: a SEER figure from a 2019 article cannot tell you whether a quote reading SEER2 is good, bad or identical. That is why we publish no conversion factor. We do not publish a SEER-to-SEER2 conversion factor. DOE states that ratings on the new metrics are "not directly comparable" to ratings on the original metrics, and that compliance must be determined from the measured SEER2, EER2 or HSPF2 value. Approximate multipliers circulate widely, but they vary by equipment type and configuration, and using one to compare an old article's number against a number on today's quote is how homeowners end up believing they were offered less efficiency than they were. Compare like with like: ask for the SEER2 figure, and check it against the AHRI certificate. The nationwide minimum for a split-system air conditioner is 13.4 SEER2, and for a split-system heat pump 14.3 SEER2 with 7.5 HSPF2. [What each metric measures](https://hvacbuddy.shop/efficiency/) · [minimums by region and state](https://hvacbuddy.shop/efficiency/standards/). ## What should a bid show you? Three bids rarely quote the same job, so comparing headline price compares three different things. The one that was done properly shows its work, and you can check it line by line: - Model numbers for the outdoor unit, indoor coil, and air handler or furnace. - The **AHRI reference number** for that exact combination. A rating applies to a matched system, not to an outdoor unit on its own. - The SEER2 and, on a heat pump, the HSPF2 of that combination. - The Manual J result the sizing came from. - The measured static pressure and any duct work included. - The permit, and who pulls it. - Labour warranty, separate from parts, and whether registration is required. [The full red-flags checklist](https://hvacbuddy.shop/hiring/). ## What actually drives the cost? We publish no national average price, and the reason matters: an average across every house, region and system type is not a number you can act on. A replacement that includes duct modification, an electrical upgrade and a permit is a different job from a straight swap, and both read as "system replacement" on a one-page proposal. What actually drives your number: - **Equipment capacity and tier**, which should come from the Manual J rather than the old nameplate. - **The ducts** — whether they can move the air the new equipment needs, and what it costs if they cannot. - **Electrical work**, if a circuit or panel change is required. - **Permit and inspection**, usually required. - **Refrigerant** — current equipment uses R-454B or R-32; remaining pre-2025 R-410A stock may price differently. [What a bid should itemise](https://hvacbuddy.shop/costs/) · [operating cost calculator](https://hvacbuddy.shop/calculators/). ## What should you know about refrigerant? Refrigerant circulates in a sealed loop. It is not consumed the way fuel or oil is, so a system that is low on charge **has a leak**. Adding refrigerant without finding and repairing that leak treats the symptom, vents the new charge over the following weeks, and costs you the same money again next season. It is also regulated. Only Section 608 certified technicians may purchase refrigerants intended for use with stationary refrigeration and air-conditioning equipment. The restriction covers ozone-depleting substances and non-ozone-depleting substitutes — including HFCs — in cylinders, cans or drums. Wholesalers must record the purchaser's name, the date of sale and the quantity. There is one exception that confuses people: small cans of refrigerant for *vehicle* air conditioning are still sold without certification. That exception is for cars and does not extend to the equipment in your house. For new equipment, the 700 GWP limit in force since January 1, 2025 is why current systems ship with R-454B (GWP 465) or R-32 (GWP 675) rather than R-410A (GWP 2088). R-410A inventory built before 2025 can still be legally installed — EPA removed the installation deadline on May 21, 2026. [The full timeline](https://hvacbuddy.shop/refrigerants/). ## How can you verify any of this yourself? Everything regulatory on this site traces to a primary source and carries the date it was read: DOE for efficiency standards, EPA for refrigerants and Section 608, the IRS for tax credits, and ACCA for load calculation. The sources for this page are listed at the end with the date each was consulted. If you find a different figure elsewhere, check two things before deciding which to believe: whether the page says which generation its efficiency metric belongs to, and whether it carries a visible review date. Most of the outdated content in this category fails both tests. ## Why this needs a professional **This work involves refrigerant, combustion, or line voltage and requires a licensed, EPA-certified technician. This page explains the problem and what a professional will do — it is not a repair procedure.** A technician will arrive with gauges, a leak detector and a multimeter, measure operating pressures and superheat and subcooling, and find the cause rather than treating the symptom. Ask for the diagnosis in writing before authorising any repair, and if you are told there is a leak, ask to be shown where it is. **Jurisdiction notice. **Efficiency standards, refrigerant rules, incentives, and licensing are set federally, by region, and by state, and they change. This page reflects the cited federal sources as of 2026-08-17. Verify before purchasing. ## Related questions - [how much does HVAC freon cost?](https://hvacbuddy.shop/questions/refrigerants-and-phasedown/how-much-does-hvac-freon-cost/) - [how much is HVAC refrigerant per pound?](https://hvacbuddy.shop/questions/refrigerants-and-phasedown/how-much-is-hvac-refrigerant-per-pound/) - [what are the best refrigerant monitoring systems for HVAC compliance?](https://hvacbuddy.shop/questions/refrigerants-and-phasedown/what-are-the-best-refrigerant-monitoring-systems-for-hvac/) - [can you buy HVAC refrigerant?](https://hvacbuddy.shop/questions/refrigerants-and-phasedown/can-you-buy-hvac-refrigerant/) - [how much do HVAC companies charge for freon?](https://hvacbuddy.shop/questions/refrigerants-and-phasedown/how-much-do-hvac-companies-charge-for-freon/) - [how much do HVAC companies charge for R-410A?](https://hvacbuddy.shop/questions/refrigerants-and-phasedown/how-much-do-hvac-companies-charge-for-r-410a/) - [How correct equipment size is decided](https://hvacbuddy.shop/sizing/manual-j/) - [What SEER2, EER2 and HSPF2 mean](https://hvacbuddy.shop/efficiency/) - [Refrigerants and the phasedown](https://hvacbuddy.shop/refrigerants/) - [Incentives: what expired and what remains](https://hvacbuddy.shop/incentives/) Sources (2) - U.S. Environmental Protection Agency — [Refrigerant Sales Restriction (Section 608)](https://www.epa.gov/section608/refrigerant-sales-restriction) (accessed 2026-08-17) - U.S. Environmental Protection Agency — [Technology Transitions HFC Restrictions by Sector](https://www.epa.gov/climate-hfcs-reduction/technology-transitions-hfc-restrictions-sector) (accessed 2026-08-17) By [HVACBuddy Editorial Team](https://hvacbuddy.shop/authors/editorial-team/). Last reviewed: 2026-08-18. Verified: 2026-08-17 ## Also asked as - how to recover refrigerant HVAC? HVACBuddy publishes independent information. We do not install or service equipment, we do not dispatch contractors, and we do not sell leads. Nothing here is engineering, tax, or legal advice.